Decorative interior putty Caparol StuccoDecor Di Perla Silber acrylic velvet with metallic sheen, 1.25l

Decorative filler for interior work with a metallic sheen.

Caparol Stucco DI PERLA – decorative plaster with a metallic sheen for individual decoration of interior walls and ceilings

Scope of application:

For high-quality decoration of interior surfaces of hotels, cafeterias, restaurants, offices, doctor's offices, apartments, rooms in clinics, etc.

• environmentally safe;
• does not contain solvents and softeners;
• diluted with water;
• capable of diffusion;
• easy to use;
• withstands high mechanical loads.

Container:  Plastic bucket: 1.25 l, 2.5 l.

Color: Silver - base.

Technical information according to DIN EN 13300:

• Wet abrasion: class 2;
• Grain size: fine.
• Density: approx. 0.97 g/cm3.

Base:

Bases must be clean, dry, with load-bearing capacity. The surface must first be puttyed to a smooth state (for example, using Caparol Glattspachtel) so that there are no unevenness, damage or shrinkage cracks. Then it is necessary to cover the surface with Samtex E.L.F. according to the technical instructions without a structure with a color tone corresponding to the tone of the subsequent coating

• working stage.

Evenly apply the putty compound Capadecor StuccoDecor DI PERLA of the desired color tone, diluted with water by approximately 20%, on the prepared surface with a roller with a short pile. Material consumption is approximately 40 ml/m².

• working stage.

Apply the putty compound Capadecor StuccoDecor DI PERLA without diluting the same color tone with a Venetian trowel until completely covered, after a technological break treat/structure the surface with the same trowel. At the same time, a characteristic velvety surface is obtained. Consumption of Capadecor StuccoDecor DI PERLA material is approximately 80 ml/m².

Attention!

In order to avoid visible layering, it is necessary to cover the surface using the "wet on wet" technique. without breaks The application of the material is affected by drafts and elevated temperature of the base.

Consumption:  approximately 120– 150 ml/m2 for a smooth coating with two-layer application. The exact consumption is determined by trial at the object.